It is advisable that you delete the folders inside SoulseekQT at the location Users/'your user name'/AppData/Local. Maybe your router isn't accepting UPnP requests to open the port and just needs to be rebooted or its configuration adjusted. and are meant to find an open port and a service running, with a vulnerability that can be exploited, so in the future the attacker can get remote access to the computer. Maybe your router has the port open, but your ISP is blocking the incoming traffic before it ever gets to you (some UK ISPs do this). Either way, the port appears "closed" to the outside world. Under certain fairly common circumstances, the listening port may not be. programmed to run over TCP or UDP however, it is. If the port isn't also open on your computer, then the traffic is rejected at your computer. The Soulseek client sets up a listening port to accept incoming TCP connections. FastTrack, Freeenet, BitTorrent, Opennap, Edonkey, Soulseek and MP2P. If the network between the two point have a very high quality, UDP is absolutely faster than TCP, but in some other case such as the GPRS network, TCP may been faster and more reliability than UDP. If the port isn't open at the router, then the traffic is rejected at the router. It is meaningless to talk about TCP or UDP without taking the network condition into account. It's like your computer is bypassing the router and sits directly on the Internet, but just for traffic on that one port. In other words, it asks your router to accept and forward any incoming traffic marked as being for that port to the same port (usually) on your computer. SoulseekQt listening port is set to 40109. Because UDP is connectionless and fire and forget, you can send a lot of packets to a recipient very. Between TCP and UDP, UDP is lower latency as you mentioned, but that comes at the cost of reliability. However, SoulseekQt will not connect, even after a restart. Since WebSockets is built on TCP with a bit of overhead during connection setup, this is more of a comparison between TCP and UDP. What I can say is that Soulseek is like most any other networking client: When it starts up, it asks the OS to let "listen" on a couple of TCP ports, and it also asks your router (via UPnP) to open and forward corresponding ports. For SoulseekQt, I have set them as follows: TCP 40109 to 4019 to 40110 I then tested that these ports are actually open using: telnet mypcip 40109 telnet mypcip 40110 The telnet commands confirm that both ports are open. We don't know what you know about how computer networks work, and this isn't the place to explain it all to you. Think and investigate and try different things. There's no magic "just make it work" button.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |